Rough-in is fast and easy with FAS Power. Pre-fabricated floor brackets slide under the sill plate with no vertical measuring needed. Wall brackets with pre-mounted boxes and rings quickly attach to the stud with switches and switch/outlet combinations in place. And for fast job starts, FAS Power products are prepackaged and shipped to the requirements of the contractor.
To save time in the planning process, use our online configurator.
Each FAS Power assembly includes:
- Floor or wall bracket with one to four gang openings
- Pre-installed boxes
- Pre-installed plaster rings are available in 1/2" to 2" raise or adjustable style
- Far side support arms
- PlugTail or standard devices can be pre-wired to MCAPTM cable or packaged separately
- CJ6 wire manager
FAS Power can benefit you in many ways:
- Fast job starts – FAS Power is packaged and shipped per contractor instructions
- Reduced rough-in time – Boxes are pre-mounted and grounded
- Pre-installed plaster rings – can be specified to fit any wall thickness
- Pre-wired to MC cable – FAS Power assemblies can be pre-wired to pre-cut MCAPTM cable lengths
- Wide variety of device choices – PlugTail allows you to make device choices at finish or devices can be pre-installed and protected during drywall installation
- Painless inspections – All assemblies are UL or ETL listed
- Faster finishes – with pre-wired assemblies, just install your PlugTail outlet/switch or remove the cover from pre-installed devices.
|
Click on image to enlarge.
